- 8 -
English
Chapter 2
SAFETY INFORMATION
–
The machine must be handled with the aid of specific means (crane,
forklift etc.) by qualified personnel capable of observing the safety
requirements.
– When using the lifting means, insert and/or fasten the devices
(hooks, forks etc.) ONLY into the points provided on the package
and/or the machine.
– Transport the machine suitable means of adequate capacity.
– Make sure the machine and its components are properly fastened
to the transport mean.
Check the machine dimensions and affix proper signs if the machine
overall dimensions exceed the values allowed by road regulations.
– The minimum and maximum temperature (during transport and/
or storage) must fall within the range allowed in order to prevent
damaging the electrical components.
–
Install the machine ONLY in spaces free of explosion and /or fire
risks.
– Avoid the spaces exposed to atmospheric and corrosive agents.
– Assess, prior to installation, if it is necessary to draw up a “safety
plan” in order to protect the safety of the personnel involved.
– Provide proper safety conditions when operating at high altitudes
areas that are dangerous and hard to access.
– Install the machine according to the minimum perimeter indicated
by the manufacturer and the surrounding activities.
– Should the machine interface directly/indirectly with other machines
or production lines, draw up the installation design of the machine.
The design must include all the operating conditions in order to
comply with the standards in force on safety at work place.
– Check that the installation space is properly ventilated in order to
avoid air concentration unhealthy for the operators.
– Apply the most suitable solutions for reducing the noise levels and
the acoustic pollution to minimum.
– Carry out the electrical connections professionally and in full
compliance with the instructions provided by the manufacturer and
the specific regulations in force.
The electrical connections must be carried out EXCLUSIVELY
by operators with particular expertise in the field of intervention.
‒
The operator must test the machine and check, through a general
test, that the machine can be commissioned without any risk for
the operator.
‒ Dismantle all the packaging components in compliance with the
standards in force in the country of installation.
Non compliance with the instructions given may cause risks
for safety and health of the persons and economic damages.
