RoboGuard TRX005, Technician Manual

Page: 20 / 44

Roboguard 20
etc). The resistance should change from 0ohm N/C to open
circuit N/O or vice-versa. The
yellow wire is always N/O, rated at
1Amp and is connected to the siren -ve (generally about 12 Watt, siren
positive to external power).
Optional Features: (OFF = Default)
There is a 4-way DIP switch on the inside of the HQ that provides you
with the following optional settings:
Switch 1: ON = 3min, OFF = 30sec. ( Timing on the siren wire)
Switch 2: ON = Future use, OFF = at all times
Switch 3: ON = Future use, OFF = at all times
Switch 4: ON = entry delay of 30sec, exit delay of 1min 10sec
allowing one to exit the property. Only works with remote arm/disarm.
When arming the HQ a regular beep will be sound on the speaker
followed by a siren bark to indicate armed. If the Remote arm button
is pressed for a second time the HQ will arm instantly.
On entry, if a Roboguard is triggered the speaker will beep, but after
30 sec the siren and output switches will be triggered if not disarmed.
(Entry / exit delay has 5 triggers then will not trigger the siren
again)
Additional Info:
If the HQ is connected to a siren via the yellow wire it will always
trigger the siren for Tamper, whether the HQ is armed or not.
For siren connections longer than 10 metres use a relay to drive the
siren.
To avoid the 5-trigger limit on the yellow wire, set your HQ to Setting
2, output format 2. Connect the white wire to a timer relay to drive the
siren every time intruder is triggered. To be able to hear the unit arm
and disarm via the siren bark, the yellow wire should be connected to
the output side of the timer relay.
Never put your HQ anywhere near a ‘Remote Blaster’ (normally used to
change DSTV channels from the bedroom). These items have a large
area of electro-magnetic interference around them and they can
prevent communication with some or all Roboguards.
Always carry a known, working HQ with you to diagnose problems.