RoboGuard TRX005, Technician Manual

Page: 15 / 44

Roboguard 15
To program guards into the HQ, follow these steps:
1. Connect the Battery: NOTE: Your dealer may have done this
already. This is also a good time to set your output ports – see
program mode D.
2. Using the Allen key supplied, remove the 4 securing screws at the
back of the HQ, locate the battery wire and clip it into the 2 pin box
located on the bottom left of the PC board, (see picture below), close
the back cover and replace the screws. Connect your HQ to the 12-
Volt charger supplied and let it charge for 24 hrs to ensure long
battery life.
3. Your HQ is now in Standby Mode. You can now program your
Roboguards into the desired Zones on the HQ.
4. Program Modes A and B can each accept 4 Roboguards. If you have
more than 4 Roboguards you will have to use both modes, if you
have 4 or less then you can choose to use Mode A and/or Mode B.
NOTE: Roboguards that share a Zone in Mode A and Mode B will
both be turned on and off together, so ensure that they are
positioned adjacent to each other in your garden.
PROGRAM MODE A: (FIRST 4 ROBOGUARDS)
1. Press and hold the Tamper Button until you hear a beep then
release. The Tamper light will burn solid red.
2.
Press and release the desired Zone button on the HQ, it will burn
solid green.