RoboGuard TRX005, Technician Manual

Page: 16 / 44

Roboguard 16
3. Press and release the Tamper Switch on your
Roboguard. The Roboguard will sound 4 beeps
and transmit a tamper signal, your HQ will
emit 10 beeps, and all the lights will flash to
indicate successful programming.
4. Press any Zone Button to return to Standby
Mode (or the HQ will time-out in 20 seconds).
5. To program the next Roboguard, press and hold the HQ Tamper
Button until you
hear a beep . The Tamper light will burn solid red
and the previously programmed Roboguard Zone (s) will burn solid
green. Press and release the desired Zone button on the HQ, it will
burn solid green and the other green lights will turn off.
6. Press and release the Tamper Switch on your Roboguard. The
Roboguard will transmit a tamper signal, your HQ will emit 10 beeps,
and all the lights will flash. Press any Zone Button to return to
Standby Mode or let the HQ time-out.
7. When your Roboguard is triggered (intruder) in Mode A:
A. The HQ will beep the corresponding number of times as the Zone.
The HQ will beep once for Zone 1, twice for zone 2 and so on.
B. The green Zone light will start to flash for visual identification of
the triggered Roboguard. The green Zone light will continue to
flash until it is re-set. This does not affect the operation of your
system.
C.
To reset the flashing Zone light to solid green – press the Zone
button twice. (Once to turn the Zone OFF –disarm, once to turn
the Zone back ON – re-arm.)
PROGRAM MODE B: (ADDITONAL 4 ROBOGUARDS)
1. Press and hold the Status Button until you hear a beep then
release. The Status light will burn solid red. (Press Tamper to exit
early and effect no changes)
2. Press and release the desired Zone button on the HQ, it will burn
solid green.
3. Press and release the Tamper Switch on your Roboguard. The
Roboguard will transmit a tamper signal, your HQ will emit 10 beeps,
and all the lights will flash to indicate successful programming.
4. Press any Zone Button to return to Standby Mode (or the HQ will
time-out in 20 seconds).
5. To program the next Roboguard, press and hold the Status Button
until you
hear a beep . The Status light will burn solid red and the
previously programmed Roboguard Zone (s) will burn solid green.