28
MbEr
This messsage informs you that the main PCB does not communicate correctly with the Control Board.
C1Er (color-wheel 1 error)
This messsage will appear after the reset of the fixture if the magnetic-indexing circuit malfunctions (sensor
failed or magnet missing) or the stepping-motor is defective (or its driver circuit on the main PCB). The color-
wheel1 is not located in the default position after the reset.
C2Er (color-wheel 2 error)
This messsage will appear after the reset of the fixture if the magnetic-indexing circuit malfunctions (sensor
failed or magnet missing) or the stepping-motor is defective (or its driver circuit on the main PCB). The color-wheel
2 is not located in the default position after the reset.
SGEr (static gobo wheel error)
This messsage will appear after the reset of the fixture if the magnetic-indexing circuit malfunctions
(sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main PCB). The static
gobo wheel is not after the reset in the default position.
rGEr (rotating gobo wheel error)
This messsage will appear after the reset of the fixture if the magnetic-indexing circuit malfunctions
(sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main PCB). The rotating
gobo wheel is not after the reset in the default position.
IGEr (rotating gobo indexing error)
This messsage will appear after the reset of the fixture if the magnetic-indexing circuit malfunctions
(sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main PCB). The rotating
gobo is not after the reset in the default position.
EFEr (effect wheel error)
This messsage will appear after the reset of the fixture if the magnetic-indexing circuit malfunctions
(sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main PCB). The effect
wheel is not after the reset in the default position.
IEEr (effect wheel indexing error)
This messsage will appear after the reset of the fixture if the magnetic-indexing circuit malfunctions
(sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main PCB). The rotating
effect wheel is not after the reset in the default position.
FtEr
This error message informs you that the fixture was overheating (occured if the ambient temperature is 45°
C or more) and that the relay switched off the lamp. This message will appear on the display until the temperature
will be on a suitable level, then the display will show the "
HEAt" message meaning the lamp is too hot (explanation
see above).
SnEr
This message appears if the lamp lighting sensor is failed.
MAEr
The message informs you that the fixture was addressed as a master and DMX signal is connected to its
input.Disconnect the DMX controller from fixture's input and address the fixture as the master again.
SnEr
This message appears if the lamp lighting sensor is failed.
Caution: The message is disabled if the lamp light sensor (function "En.Sn.") is switched Off.
PoEr
This message will appear if the fixture was shortly disconnect from the main.
FrEr
It will appear if the frequency of the main is not standard 50 or 60Hz.
