26
Lamp adjustment
This function can be used when you make the fine adjustment of the lamp.If you select "LAAd" pressing by
[Enter]-button ,all effects will be canceled,shutter will be opened and the dimmer intensity will be set onto 100%.By
using the options "PAn, tilt,Foc" you can focus the light on a flat surface (wall) and perform the fine lamp
adjustment.
Fixture code
The option contains identification code (1-9999) for the fixture, which is used for the master/slave operation.
Adjusting the default positions of color, gobo and effect wheels
By this function you can calibrate and adjust the color, gobo and effect wheels to their standard/right positions.
Use the [Up] and [Down] keys to browse through the adjusting menu - the display shows step by step these
messages: "PAn, Tilt,FPAn,FTilt, SPEd,Func, Col1, Col2, EFEC, SGob, rGob, Grot, IriS, FoC, Stro, dinr" by
which you can adjust the fixture to the required / desired position (0-255) before the function calibration. Then
when the positioning is finished use the last "FCAL" function (Fixture calibration).
1. Calibration via the control board
Press [Enter] and the [Up] and [Down] keys in order to display the following messages: "Col1,Col2 ,EFEC,SGob,
rGob", for very smooth function calibration. Select one of them, press [Enter] and use the [Up] and [Down] keys
in order to adjust their right value from 0 to 255. Then press [Enter] to confirm or [Menu] to cancel and return to
the menu. This can be repeated for each calibration parameter if it is required. When the calibration is finished, it
is necessary to use the "ArES" function in order to write the calibration values to the memory (EPROM) and to
make a reset in order to check the newly adjusted positions of the colour, gobo and effect wheels. When the reset
of the fixture is finished, the display will show the "FCAL" message. Press [Enter] to repeat the calibration or
[Menu] to return to the "AdJ" menu.
2. Calibration via the external controller
Press [Enter] and the [Up] and [Down] keys in order to display the following messages: "Col1,Col2,EFEC,
SGob, rGob,", - calibration parameters. Select one of them and press [Enter].
Now you can calibrate the the colour, gobo and effect wheels by your controller. The DMX calibration protocol is
described in the table.
