To change the metering mode on the device:
1. Open the
visual feedback
tab in the
STATE
section.
2. Open "Global Meters" using the corresponding button.
3. Press the first button to toggle between Peak and RMS metering.
This is a global setting which affects both the front panel level meters and the remote
control interface.
8.3.3. Persistent Clipping Notifications and Peak Hold
The maximum level of signals can be saved and shown on the front panel and web remote. Clipping is
detected when three consecutive samples reach digital full scale (0 dBFS). The duration of how long the
maximum level or clipping is shown can be manually changed to either five seconds or until they are
manually reset.
This is a global setting which affects both the remote control and the device.
On the device, an over notification is signaled as a fast flashing (red) of the
channel LED.
To switch over notifications on or off:
1. Open the
visual feedback
tab in the
STATE
section
2. Change
Peak Hold
to either:
◦
5s
to notify for five seconds
◦
On
to notify until manually reset
RME 12Mic User’s Guide
8.3. Front Panel Illumination |
30
