The device lock does not protect against changes over network or MIDI remote control protocols. The
lock configuration is not stored within a
preset
.
A four to six digit code can be configured on the device. If this code is lost or forgotten, it is
not possible for the user to unlock the device. Contact your support for assistance.
8.2.1. Locking the Device
In order to lock the device, proceed with the following steps:
1. Open the
lock
tab in the
STATE
section (
see Section 2.3, “Controlling the device”
2.
(optional)
Set Code:
enter a four to six digit code with the encoder.
3.
(optional)
Activate the
Auto Lock
toggle to lock after one minute.
4.
(optional)
Select
Lock Device Now
to lock immediately.
Remember or write down the code shown in
SET CODE
. It is not possible to unlock the
device without this code. A unique secondary code (PUK) can be obtained from RME
Support upon request with a proof of purchase and device serial number.
To delete the code,
move the cursor on the code and push the encoder. "No code" will be displayed.
8.2.2. Unlocking the Device
To unlock the device
temporarily
:
1. Push and hold the encoder button for four seconds.
2. (if a code was set) Enter the code using the encoder and choose "Done".
The device will lock again after a timeout of one minute.
To unlock the device
permanently:
RME 12Mic User’s Guide
8.2. Device Lock |
28
