EAGLE 2 Operator’s Manual
Using Setup Mode • 119
Updating the Span Factor Setting
With
SPAN FACTOR
set to
ON
(factory setting), the EAGLE 2 will display the span
adjustment range for a sensor in the calibration results screen while in Single Calibration.
The span adjustment shows how low and how high the reading could have been adjusted.
With
SPAN FACTOR
set to
OFF
, this span adjustment does not appear in the calibration
results screen.
1. From the main menu, place the cursor next to
SPAN FACTOR
.
2. Press and release POWER ENTER RESET. The Span Factor Screen appears.
3. Use AIR
▲
YES or RANGE
▼
SHIFT to display the desired setting.
4. Press and release POWER ENTER RESET to save the setting and return to the main
menu.
Updating the Language Setting
This setting allows you to select the language for the EAGLE 2’s user interface. The
available choices are English (factory setting), Spanish, French, Italian, and German.
1. From the main menu, place the cursor next to
SELECT LANGUAGE.
2. Press and release POWER ENTER RESET. The Select Language Screen appears
with the cursor in front of the current language.
3. Use AIR
▲
YES or RANGE
▼
SHIFT to move the cursor in front of the desired
language.
If you do not wish to select a new language, either press and release DISPLAY
ADJUST NO or move the cursor all the way to the bottom of the list in front of
END
and press and release POWER ENTER RESET. The unit will return to the main
menu.
4. Press and release POWER ENTER RESET to save the new language setting and
return to the main menu. The EAGLE 2’s user interface will now be in the newly
selected language.
NOTE:
If you select a language other than English, a prompt will appear during startup
that allows you to change the language back to English if desired.
SPAN FACTOR DISPLAY
UP/DOWN THEN ENTER
ON
SELECT LANGUAGE
> ENGLISH
ESPANOL
FRANCAIS
ITALIANO
DEUTSCH
www.
.com
1.800.561.8187
