WWW.RSIWW.COM
35 of 45
B-4
S-5B
1
S-2C 11
4
Connector
QTY
W-1
3
Panel
QTY
24” x 57”
Connector
QTY
S-7
10
*
NOTE: W-2 panels are
installed in step 8.6
8.4A
8.4D
W-1
W-1
W-1
8.4c
Hold two profiles together in place at ridge using one
B-4 connector. Insert two T-bolt assemblies, line up
center hole with long hex bolt in roof ridge. Secure
T-bolt assemblies
as shown.Place
washer on long bolt
and secure with
S-2C cap.
F-1
F-1
R-1
B-4
Return to back to install section three and
remove bungee cord nearest to back.
Remove plastic film from both sides of
one W-1 panel. With side marked “ UV
Resistant” facing outside, install the next
panel on the left at the back. Push panel
into roof ridge channel until the other
end rests on gutter ledge and then slide
towards F-1 profile at back.
Continue working from back to
finish section three. Remove
plastic film from both sides
of one W-1 panel. With side
marked “ UV Resistant” facing
outside, install the next panel
on the right at the back. Push
panel into roof ridge channel
until the other end rests on
gutter ledge and then slide
towards F-1 profile at back.
Repeat to install W-1 panel
on left.
NOTE: VIEWS FROM INSIDE.
From inside, hold profile in
place with one B-4 connector.
Secure with two T-bolt
assemblies as shown.
8.4B
F-1
B-4
F-1
From inside, hold profile in place with
one B-4 connector. Secure with two
T-bolt assemblies as shown.
8.4e
F-1
B-4
F-1
NOTE: VIEWS FROM INSIDE.
Hold two profiles together at ridge using one B-4
connector. Secure with two T-bolt assembies.
8.4f
R-1
F-1
F-1
B-4
