WWW.RSIWW.COM
27 of 45
NOTE: VIEW FROM OUTSIDE.
NOTE: VIEW FROM OUTSIDE.
From outside fit F-7 profiles into each side of front. Begin with either
side. Arrange F-7 profile so channel lines up with tops of panels. The
side of the profile rests against cut angle of F-8 profile. The top end
touches edge of F-4 center profile and bottom end touches top of
G-1 gutter. Position both F-7 profiles.
Use C-1 connector with three T-bolt assemblies to secure each outside corner. Make sure all
profiles line up flush against each other. Repeat on other side.
Check inside corners to ensure B-7 connector is still in
proper position. If it needs adjusting, repeat steps 5.7
and 5.8C through 5.8D until
each corner is set.
5.8A
5.8B
5.8c
NOTE: VIEWS FROM INSIDE.
F-4
F-8
F-4
F-8
G-1
C-1
F-7
F-7
F-6
G-1
F-6
B-7
F-7
S-2C
6
C-1
2
S-7
4
QTY
Profile
F-7
2
56”
F-8
F-7
G-1
G-1
F-7
F-8
F-4
