Operator's Manual
RE741 Perimeter™ Ladder Pod
Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5
14
POD CURTAIN ASSEMBLY INSTRUCTIONS
23. Assembly Pod Curtain as follows:
a. Attach the (4) uprights (TP162) to the platform using (4)
provided 1/4-20 x 2” bolts, locknuts and washers.
SEE FIGURE 14
NOTE:
DO NOT tighten all nuts and bolts completely!
b. Attach the (4) flat bar supports (AL7) to the inside of
uprights using (4) provided 1/4-20 x 1-1/4” bolts and
locknuts.
c. Attach the opposite end of flat bars supports to the
platform using (4) provided 1/4-20 x 1-1/2” bolts and
locknuts.
d. Insert the (2) curtain rails (TP161) into the (2) spanner
tubes (TWR26) forming a square. Using (4) provided 1/4-20
x 1-1/4” bolts, locknuts and washers, secure the curtain rails
and spanner tubes together.
e. Attach the assembled rail square to the outside of
uprights using (4) provided 1/4-20 x 2” bolts, locknuts and
washers.
You must now tighten all nut & bolt assemblies
securely. DO NOT crush tubing when tightening!
f. The side of curtain with numerous Velcro loops is the top
side of curtain. Attach the top side of curtain to the curtain
frame by wrapping all Velcro attachment points around
metal tubing and securing together. Curtain should be
positioned with zippered door on the front/center of your
ladder for entry and exit purposes.
g. Once top of curtain is secured properly, pull the bottom
edges of curtain down around the foot platform. The sewn-
in elastic bungee will securely grab the lower corners of
your platform. Attach remaining Velcro loops on bottom/
back seam of curtain securely. Once you are certain all
assembly is complete and correct, proceed to Uprighting
and Use Instructions.
FIGURE 14
SPANNER TUBE
POD
CURTAIN
RAIL
1/4-20 x 1 1/2
BOLT
1/4-20 x 2
BOLT
1/4-20 x 1 1/4
BOLT
1/4-20 x 2
BOLT
WASHER
LOCKNUT
1/4-20 x 1 1/4
BOLT
WARNING
Only use approved RETI parts. Failure to do so may result
in serious injury or death!
