Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5
5
Operators Manual
RE741 Perimeter™ Ladder Pod
1/4-20 x 2 1/2 BOLT
LOCKNUT
STEEL WASHER
J-RECEIVER TUBE
1/4-20 x 1 1/2 BOLT
STEEL WASHER
LOCKNUT
REAR
LEG
POCKETS
ASSEMBLY AND USE INSTRUCTIONS
SELECTING A GOOD LOCATION
Assemble this product only in areas that meet the following
criteria! No overhead power lines near area; open, flat, level, dry
ground of sufficient size to allow for assembly, up righting and
climbing. Approximate area needed for assembly is 14’ X 24’.
POD LADDER ASSEMBLY INSTRUCTIONS
Tools needed: Two 7/16” wrenches, two 1/2” wrenches, and
a tape measure to measure level ground area needed &
cross brace length.
NOTE: It is highly recommended that as much assembly
as possible be done in a garage setting because of
hardware amount and time involved! Allow between two
and four hours for assembly.
IMPORTANT ASSEMBLY STEP:
Do not tighten any nut and bolt combinations completely
until all parts are assembled together! Finger tighten
plus one turn of a wrench only! This will temporarily hold
the lock nut on the bolt while helping alignment of all
parts! After all parts are assembled together, all nut &
bolt combinations must be completely tightened.
1. Attach (2) platforms (TP100) together using (2) provided
1/4-20 x 2-1/4” bolts, locknuts and steel washers. SEE
FIGURE 1.
DO NOT tighten all nut & bolt assemblies
completely!
2. Attach the assembled platforms to the (2) provided
J-receiver tubes (TP109) using (4) provided 1/4-20 x 2-1/2”
bolts, locknuts and steel washers. SEE FIGURE 2
3. Attach the two rear leg pockets w/ plates (TP151 & TP152)
to the bottom of assembled platform using (6) provided
1/4-20 x 1-1/2” bolts, locknuts and steel washers.
SEE FIGURE 3
NOTE: Make sure the pockets are orientated outward,
away from each other.
4. Attach the seat post (TP11) to the assembled platforms
using (4) provided 1/4-20 x 1-1/2” bolts and locknuts.
SEE FIGURE 4
1/4-20 x 1 1/2” BOLT
LOCKNUT
FIGURE 1
FIGURE 4
FIGURE 2
FIGURE 3
LOCKNUT
STEEL WASHER
1/4-20 x 2 1/4
BOLT
CUT VIEW OF PLATFORMS
