Operator's Manual
RE741 Perimeter™ Ladder Pod
Check for parts online at www.HuntRiversEdge.com or call 800-450-EDGE (3343) M-F 8-5
4
WARNING
Do Not use this product until you have watched the
included treestand safety DVD, understand it, and
practiced the techniques for safe hunting discussed in
this DVD.
Read and perform all inspection and maintenance tasks
before each and every use. Replace any questionable
components immediately with RETI original replacement
parts.
Do Not crush tubing when tightening bolt assemblies!
Identify and familiarize yourself with all parts before you
start. Bolt identification chart can be found in the back.
Double check assembly steps to be certain you have
correctly assembled this product.
Never use any product that has not been maintained or
inspected properly - Your life depends on it!
Always wear the appropriate footwear when using a free
standing platform stand. A good non-slip safety boot is
important to your personal safety. Be especially careful
that boot laces do not get hooked on the stand or any
of its components (tuck shoelaces into boots before
climbing).
Do not position this product on a slope, unlevel, or wet
ground. It may tip over and serious injury or death may
occur.
Ground should be such that ground stakes (not included)
can be driven into the ground through holes provided in
foot pads. This will help prevent pod from tipping over in
strong winds. You will need to make or purchase (4) ground
stakes. Stakes should be 3/8 inch rod x 24 inches long.
INSPECTION AND MAINTENANCE SCHEDULE
BEFORE EACH USE PERFORM THE FOLLOWING:
• Inspect all webbing, rope, cord, and strap assemblies for
wear or damage.
• Inspect cables and/or cable ends for damage or kinking.
• Inspect all hardware and chain components for damage.
• Inspect for any structural damage to product. (If any exists
call RETI customer service.)
• Inspect all nut and bolt assemblies to be certain none are
loose.
• Inspect for any missing parts.
• Lubricate all pivot and slide together points with powder
graphite, petroleum jelly or silicone spray to prevent noise,
wear and rust.
• Inspect entire product for any rust, corrosion, cracks,
freezing, excessive heat or rotting damage that may effect
the safety of your product. Discard any questionable
product.
• Inspect entire product for any structural damage - pay close
attention to all weld locations. (Return to factory for repair or
discard product if any damage is found.)
• Using correct wrenches inspect all nut & bolt assembly
locations and snug up any that may be loose. Be careful not
to crush tubing when tightening!
• Inspect and check operation of all cables, cable ends, cord,
rope, webbing, and strap or chain assemblies. Replace with
factory new any item or assembly that shows signs of wear,
damage, kinking, or functions incorrectly.
• Inspect seat. Replace any seat with factory new that shows
signs of structural damage or wear.
• Inspect all hardware for wear or damage, also be sure you
have no missing parts.
• Never modify your stand in any way by making repairs,
replacing parts, or altering adding or attaching anything to it
except if explicitly authorized in writing by the manufacturer.
