Replacing 2U xx80 and 9800 Components | 29
2
Replacing 2U xx80 and 9800 Components
This chapter describes how to replace components in 2U SteelHead xx80, SteelCentral xx80, and
Interceptor 9800 appliances. It includes these sections:
•
“Appliances included in this chapter” on page 29
•
•
“Removing the bezel” on page 30
•
“Removing the chassis cover” on page 31
•
“Removing the riser brackets and air duct in 2U appliances” on page 31
•
“Replacing the disk drives” on page 33
•
“Replacing power supply units in 2U appliances” on page 37
•
“Replacing memory modules in 2U appliances” on page 38
•
Appliances included in this chapter
This chapter describes how to replace components in these 2U appliances:
•
SteelHead CX 5080 and CX 7080
•
Interceptor (IC) 9800
•
SteelCentral AppResponse 4180 and 8180
•
SteelCentral NetProfiler 4280 and 4280-EXP
Required tools
You need the following tools and equipment to replace appliance components:
•
You must use approved components for the appliance to function properly. Installation of
unapproved components will result in boot failure. To order components, contact Riverbed Support
at https://support.riverbed.com.
•
An antistatic strap. When you replace appliance components, you must wear a grounded ESD
antistatic strap to protect the hardware against electrostatic discharge. Make sure that the strap
makes skin contact prior to handling equipment.
