Riverbed SteelCentral AppResponse 2180, Upgrade And Maintenance Manual

Page: 30 / 82

30 | Replacing 2U xx80 and 9800 Components
Removing the bezel
• Use the Riverbed magnetic reversible screwdriver (that is, Phillips and flathead) enclosed with your
shipment to remove screws in the appliance. The magnetic screwdriver ensures screws aren’t lost in
the appliance.
Removing the bezel
This procedure describes how to remove and install the front bezel on 2U appliances.
To remove the bezel
1. If locked, unlock the bezel.
2. Remove the right end of the front bezel from the rack handle. See Figure 2-1 , letter A.
3. Pull the left side of the front bezel toward you to release the latches on the left end from the rack
handle. Figure 2-1 displays a 2U appliance.
Figure 2-1. Removing the bezel
4. Pull the bezel away from the appliance. See Figure 2-1 , letter C.
Note: The bezel that ships with your appliance might look different from the bezel in the figure.
To install the bezel
1. Insert the tab on the right end of the front bezel to the rack handle. See Figure 2-1 , letter A.
Note: Before installing the bezel, you must install the rack handles.
2. Push the left end of the bezel toward the appliance until it clicks into place. See Figure 2-1 , letter B.
3. Lock the bezel, if needed.