RITE-HITE Rave RHC 1234567-001, Installation And Owner'S Manual

Page: 21 / 56

RAVE ® FAN
Pub. No. 54450034 Rev. 4 - © DECEMBER 2014
21
MOTOR WIRING
The fan motor will receive three-phase power
from the fan control box even if single-phase
power is provided to the control box. Remove the
cover from the motor junction box. Change the
wire leads as necessary for high or low voltage.
See Figure 16 for the appropriate wiring.
CONDUIT RESTRICTIONS
Figure 15
NOTICE
Use one of the wire types listed below to
connect the fan control box to the motor.
Acceptable unshielded cable types:
THHN/THWN Min 600V 90°C
Acceptable shielded XLPE VFD cable types:
Belden 29501
AlphaWire V16014
Do not use solid core wiring of any size or
insulation class for controller output/motor
leads.
NOTICE
AC supply lines for a controller MAY share
the same conduit with AC supply lines for
one or more additional controllers.
AC supply lines for a controller and output/
motor leads for the same controller or
another controller
MAY NOT share the same
conduit.
The conduit with the incoming power and the
conduit with the power going to the motor
should be separated by a minimum of 6 in.
(150 mm).
400-480V (Wye)