RITE-HITE Rave RHC 1234567-001, Installation And Owner'S Manual

Page: 18 / 56

RAVE ® FAN
18
Pub. No. 54450034 Rev. 4 - © DECEMBER 2014
Figure 12
BLADE ATTACHMENT
1. Clean each blade with a paper towel to
remove fingerprints and dirt before the
blades are installed.
2. Set the fan blades in place on the fan hub.
3. Raise the fan blade above the arm of the fan
hub and allow the blade to slide into the slot
provided on the fan hub.
4. Attach each fan blade to the fan hub with a
22 mm bolt (provided).
5. Use a torque wrench with a 3/4 in. drive
extension to tighten the bolt to 75 ft-lb
(102 Nm).
NOTE: In the event that a fan blade is
damaged, both the damaged blade and the
blade opposite must be replaced. Replacement
blades are provided in pairs.
Figure 13
FAN LEVELING
Level the fan hub after blade attachment.
1. Hold a level across the center of the hub in
all directions.
2. Make fine adjustments with the stabilization
cables.
3. After run/test, go back and test level and
cable tension.