Riso RP-255, Technical Manual

Page: 242 / 449

[ 13 - 11 ]
CHAPTER 13. AF SCANNING SECTION (RN25 Series)
4. Removing the Original Stripper Pad Assembly
(1) Remove the original pickup assembly (refer to the removal instructions in this Chapter).
(2) Detach original stopper bracket [A] by removing one screw (M3 x 4), and remove the original stopper
[B].
(3) Using the original release lever [C], elevate down the original stripper section.
(3) Being careful not to drop the spring under the original stripper pad assembly [D], slide back the
assembly to disengage it out from the hooks and then take it out from the AF unit through the
opening.
[Precautions on Reassembly]
•
In putting the original stripper pad assembly [D] back into the AF unit, place an adhesive tape [E]
on the assembly (ref: photograph), and elevate down the original stripper section by using the
original release lever [C]. Push the assembly down into the opening under the stripper sheet [F]
and attach the spring firmly onto the assembly.
•
Use the attached adhesive tape to pull the original stripper pad assembly [D] to hook it onto the AF
unit.
•
Remove the adhesive tape once the original stripper pad assembly [D] is fixed in its position.
A: Original stopper bracket
B: Original stopper
C: Original release lever
D: Original stripper pad assembly
E: Adhesive tape
F: Stripper sheet
B
1341
A C D F
E
1342
1345 1343
F D
1344