Riso RP-255, Technical Manual

Page: 129 / 449

PAPER EJECTION SYSTEM
[ 7 - 18 ]
A
B
B D C
E F G H H G E
9. Removing the Transfer Belts
(1) Switch off the power, remove the rear cover, and remove the following components.
• Paper receiving tray
• Suction unit cover
• Suction unit
• Transfer plate
• Paper ejection wings, wing shafts
(2) Remove the paper ejection motor belt [A].
(3) Remove the E-rings [B] on the left and right of the belt pulley shaft [C], and remove the transfer belts
[D] by sliding them off the belt pulley shaft [C].
A: Paper ejection motor belt
B: Left and right belt pulley shaft E-rings
C: Belt pulley shaft
D: Transfer belt
[Precautions on Reassembly]
• Fit the left and right bearings [G] and E-rings [E] on the belt pulley shaft from outside the mounting
brackets.
• Mount the pulley [F] on the left-hand end of the belt pulley shaft [H] with the flange facing inwards.
E: E-ring
F: Pulley
G: Bearing
H: Belt pulley shaft
0744
0745
0746