Riso RP-255, Technical Manual

Page: 132 / 449

PAPER EJECTION SYSTEM
[ 7 - 21 ]
C
A
B
D
12-1. Removing the Separator (RN25 Series)
(1) Pull out the print drum, switch off the power, and remove the front cover. Remove the rear cover,
then open the System PCB bracket and remove separator fan.
(2) Move the separator air-hose band [A] to the side, and detach the hose. (The air-hose band’s knob
points upwards.)
(3) Remove the separator mounting screw (double-washer, M3 x 8: 1 pc) [B]. Remove the release arm
mounting screw (double-washer, M3 x 8: 1 pc) [C].
(4) Remove the E-ring [D] on the end of the separation shaft, and remove the bearing bush.
A: Separator air-hose band
B: Separator mounting screw (double-washer, M3 x 8)
C: Release arm mounting screw (double-washer, M3 x 8)
D: Separation-shaft-end E-ring
0754
0755