Rigol MSO8000 Series, User Manual

Page: 362 / 396

RIGOL
Chapter 20 System Utility Function Setting
20-2 MSO8000 User Guide
Remote Interface Configuration
MSO8000 series can communicate with the PC via the USB, LAN, or GPIB (requiring
to work with
RIGOL
's USB-GPIB interface converter) interface. Before using the
remote interfaces, configure the corresponding interface according to the
introductions in the following section.
LAN Configuration
Before using the LAN bus, use a network cable to connect the oscilloscope to your
local area network. The network interface of the oscilloscope is on the rear panel.
Press
Utility
→
IO
→
LAN to open the LAN Settings interface, as shown in the
following figure. You can view the current network settings and configure the
network parameters.
Figure 20-1 Network Connection Setting Interface
Network Status
Different prompts will be displayed according to the current network connection
status.
⚫
Network Config Succeeded!
⚫
Acquiring IP...
⚫
IP Conflict!
⚫
Disconnected!
⚫
DHCP Config Failed!
⚫
Read Status Fail!
Network Status
Current IP Config.
Type
MAC Address
VISA Descriptor
IP Config. Type
Network Parameters
Web Control Info.