Rigol MSO8000 Series, User Manual

Page: 110 / 396

RIGOL
Chapter 5 To Trigger the Oscilloscope
5-20 MSO8000 User Guide
Figure 5-7 Duration Trigger
Trigger Type:
Press Type , and then rotate the multifunction knob to select "Duration". Press
down the knob to select the trigger type. Then, the current trigger setting
information is displayed at the upper-right corner of the screen, as shown in the
figure below. You can also press Type continuously to select the trigger type or
enable the touch screen to tap the desired trigger type and select it.
Source Selection:
Press Source to open the signal source list and select CH1-CH4 or D0-D15. For
details, refer to descriptions in "Trigger Source" . The current trigger source is
displayed at the upper-right corner of the screen.
Note : Only when we select the channel (that has been input with signals) as the
trigger source, can we obtain a stable trigger.
Pattern Setting:
Press Code , and rotate the multifunction knob to select the pattern of the
currently selected channel. Press down the knob to select the pattern. The
corresponding pattern is displayed at the bottom of the screen. The patterns of
channels CH1-CH4 and D0-D15 are presented from left to right, as shown in the
figure below. You can also press Code continuously to select the pattern or enable
the touch screen to select it.
⚫
H: sets the pattern of the channel selected to "H", i.g. the voltage level is higher