11
20121213
GB
Technical description of the burner
4.9
Commercial boilers
The burner is suitable for operating on both flame inversion boil-
ers (*), as well as on boilers with a combustion chamber with run-
off from the bottom (three flue passes) on which the best results
for low NO
x
emissions are obtained.
The boiler front door maximum thickness must not exceed 200
mm (Fig. 4).
The coupling is ensured when the boiler is EC type-approved; for
boilers or ovens with combustion chambers of very different di-
mensions compared to those shown in the diagram of (Fig. 3)
preliminary checks are recommended.
(*) For flame inversion boilers, a kit is available to reduce the CO,
if necessary.
4.10
Burner equipment
Flange for gas train . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Slide bar extensions (TC version) . . . . . . . . . . . . . . . . . . . No. 2
Slide bar extensions (TL version) . . . . . . . . . . . . . . . . . . . . No. 4
Gasket for flange . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
M10x35 screws to fix the gas flange . . . . . . . . . . . . . . . . . No. 4
Thermal insulation screen . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Screws M12x35 to fix the burner flange to the boiler . . . . . No. 4
Flexible hoses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 2
Fitting for flexible hoses . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 2
Gaskets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 2
Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Spare parts list . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Fig. 4
200 mm MAX
D1079
Summary of Contents for RLS 120/EVi MX FS1
Page 2: ...Translation of the original instructions ...
Page 83: ......