- 17 -
P
OWER
C
ONNECTION
ALL OPERATIONS DESCRIBED IN THIS SECTION MUST BE PERFORMED BY QUALIFIED PERSONNEL
ONLY. Our Company assumes no liability for damages caused by incorrect connections or operations
not contained in this manual.
The UPS has HAZARDOUS electrical voltages inside it, even when the input and/or battery switches are off.
The inside of the UPS is protected by safety panels which should not be removed by untrained personnel. All
installation and maintenance or operations involving access inside the UPS require the use of tools and may
ONLY be performed by trained personnel.
To carry out the following operations, the UPS must be disconnected from the mains power supply,
switched off, and with all the equipment switches and fuse holders open.
1. We recommend using double-
insulated multi-core cables to be
connected, respectively, to the
“INPUT”, “OUTPUT” and
“BYPASS” terminals (if present).
2. For the cross section, refer to the
paragraph "Connection cables
cross section details".
3. The wires should be stripped and
inserted into the terminals (for the
length of the stripping, refer to the
paragraph “Connection cables
cross section details”).
NOTE:
To remove the wire, insert
a flat blade screwdriver into the
clamp slot above the wire inlet.
4. Secure the cables with the cable
glands.
5. When the installation is complete,
close the drawer cover and secure
with the screws.
Models 5-6 kVA
– Terminals cover installation
Models 8-10 kVA
– Terminals cover: standard installation
Models 8-10 kVA
– Terminals cover: 90° installation
