- 16 -
R
ACK VERSION
The sequence of operations to be followed in order to transform the UPS or Battery Box into rack version are described below.
BEFORE CARRING OUT THE FOLLOWING SEQUENCE OF OPERATIONS, ENSURE THAT:
THE UPS IS COMPLETELY SWITCHED OFF AND NOT CONNECTED TO THE MAINS POWER
SUPPLY OR TO ANY LOAD.
THE BATTERY BOX IS DISCONNECTED FROM THE UPS, FROM ANY OTHER BATTERY BOXES
AND WITH THE BATTERY ISOLATOR OPEN
1.
Pick up the panel from the sides and gently pull it away from its
position just enough to be able to rotate it.
ATTENTION: the panel must be removed carefully.
DO NOT ATTEMPT IN ANY WAY TO REMOVE THE PANEL
FROM THE UPS
2.
Rotate the panel 90° counter clockwise and reinsert it carefully
into the special housing.
3. At this point, with the UPS or Battery Box in the horizontal
position, secure the handles using the screws provided, as shown
in the figure.
NOTE:
Given the heavy weight, the use of support brackets is mandatory during rack installation (guide with L-shaped
support). For the same reason, it is recommended that the UPS and Battery Box be installed in the lower part of the
rack cabinet.
