Attach FlexLoc to
wheelchair back canes
1. Use the 4mm allen wrench to loosen
width adjustment set screws (A) and pivot
screws (B) so that the FlexLoc hardware
can be adjusted in width to match
wheelchair width.
CAUTION: Only loosen pivot screws
until teeth are disengaged. If either
pivot screw is backed off to much it will
damage the retainer clip.
2. Swing clamp hinge (C) around
back cane.
3. Swing clamping screw (D) into
clamp hinge and tighten with 4mm allen
wrench.
NOTE: FlexLoc comes preassembled
with the correct clamping screw for 7/8"
and 1" diameter tubing. If clamping to
¾" tubing, replace screws with shorter
screws included with the hardware.
4. Repeat steps 2 and 3 on opposite
side of wheelchair.
3
A
B
C
D
Y
