Available Sizes
There are four sizes of FlexLoc mounting hardware available:
Part Number Size Fits Wheelchair Widths
FL-MS
Small
10" - 14"
FL-MM
Medium
15" - 18"
FL-ML
Large
19" - 21"
FL-MX
Extra Large
22" - 24"
FlexLoc Installation Instructions
For more complete instruction, refer to web-based instructions at
www.ridedesigns.com.
WARNING: Improper attachment of the Ride Custom Back to your wheelchair
may result in serious injury. Your Ride Custom Back must be attached with Ride
Designs approved interface hardware and mounts.
I. Tools and Hardware
The following tools are included to install and adjust the FlexLoc hardware.
• 4mm allen wrench
• 2.5mm allen wrench
• 10mm open end wrench
• 2 clamp screws for ¾" back canes
• 5/8" open end wrench
II. Installation
At right is a Ride Custom Back properly
installed on wheelchair back canes
with FlexLoc hardware.
NOTE: This picture depicts a typical
installation of the standard fixed mount
(non-removable) FlexLoc onto a
wheelchair with conventional back
canes. A quick release option as
shown below is available for an
upcharge through Ride Designs.
A variety of alternatives to this
configuration are possible. Contact
Ride Designs toll free at 866.781.1633
to explore solutions to your unique
interface challenge.
NOTE: If Quick Release pin comes out of alignment, pin engagement can
be adjusted.
2
Y
