Ricoh PJ X3340, Operating Instructions Manual

Page: 72 / 104

due to shock or vibration. Further, transporting the projector in a damaged packing case may
damage the projector, so use a packing case that is in good condition.
• Do not apply volatile substances such as insecticide to the projector. Also, do not bring the
projector into long-term contact with rubber or vinyl products. Doing so may cause discoloration or
the paint to peel.
• The projector is not intended for long-term continuous operation. Further, remove the projector from
the packing case before using. If a malfunction occurs when using the projector under these
conditions, a fee is charged for repair even if the warranty is still in effect.
• Do not use locations that may be hot, such as near a heater. Doing so may cause the projector to
malfunction or reduce the service life.
• Avoid locations that may become smoky. Particulates may adhere to the optical parts, reducing the
service life and causing the image to darken.
• Using the projector close to a television or radio may adversely affect the images and sound. If this
happens, move the projector away from the television or radio.
• Moving the projector from a low-temperature location to a high-temperature location may cause
water droplets to form on the projector lens and parts due to condensation. Continued use under
such conditions may cause malfunction, so do not use the projector until the water droplets have
evaporated.
• The air is thin at high elevations, so the cooling efficiency of the projector is reduced. Select [On] in
[High Altitude Mode] before using.
• Do not use the projector in an extremely inclined position (±20° or greater). Doing so may cause
malfunction or reduce the service life.
• Do not use benzene or paint thinners. Doing so may cause the projector to warp, discolor, or the
paint to peel. Further, do not use cleaning cloths that contain chemicals.
• Clean the air filter regularly. If the filter becomes clogged, it may cause the inside of the projector
to overheat and reduce the service life of the optical parts.
5. Maintenance
70