Ricoh PJ WUL6281, User Manual

Page: 34 / 95

32
English
Introduction
Remote Control ID Setup
The IR Remote shall allow individual addressing of projectors.
Each projector shall be able to have an address set from 1 to 99.
1. ID Code 0 shall be used to address all projectors (default).
2. ID Codes 1 to 99 shall be used to address projectors set to ad-
dress 1 to 99 respectively.
To use the remote to communicate with a specifi c projector,
press “Hot Key” for 3 seconds, and then press two number
keys within 2 seconds to select an ID code. Below is the code
table for ID code 1 to 99.
ID Code Change mode
Customer
code
1
Press "Hot Key" for 3 seconds, and press "0" then
"1" within 2 seconds.
0010
2
Press "Hot Key" for 3 seconds, and press "0" then
"2" within 2 seconds.
0011
3
Press "Hot Key" for 3 seconds, and press "0" then
"3" within 2 seconds.
0012
... ... ...
10
Press "Hot Key" for 3 seconds, and press "1" then
"0" within 2 seconds.
0019
11
Press "Hot Key" for 3 seconds, and press "1" then
"1" within 2 seconds.
001A
... ... ...
98
Press "Hot Key" for 3 seconds, and press "9" then
"8" within 2 seconds.
0071
99
Press "Hot Key" for 3 seconds, and press "9" then
"9" within 2 seconds.
0072
To return to default state where all projectors can be con-
trolled, press “Hot Key” for 3 seconds, and press “0” then “0”
to select ID code 0.
For all addresses, the keycodes shall remain the same. The De-
vice code shall be modifi ed according to the selected address.