14
Using the Basic Copier Functions
Check that “Ready” is displayed on
the screen.
If any other function is displayed, press the
{
Copy
}
key
in the centre of the control panel.
Make sure no previous settings are still in effect.
If any previous settings are still in effect, press the
{
Clear Modes
}
key.
Specify the required settings.
You can specify the colour, copy thickness, and type of original.
Enter the number of copies using the number keys.
The maximum copy quantity that can be set is 99.
Load the originals.
$
Loading originals in the ADF/ARDF.
Load originals print side up in the ADF/ARDF.
1. Adjust the guide to the size of the originals.
2. Square the originals and load them face up in the
ADF/ARDF.
Do not stack originals above the limit mark.
Load paper so that the first page is on top.
$
Placing originals on the exposure glass.
Flip the original over, as shown in the illustration on the
right.
Caution:
Do not raise the exposure glass cover, or ADF/ARDF
forcefully. Doing so can result in it opening too far and
becoming damaged.
1. Raise the exposure glass cover or ADF/ARDF.
Be sure to raise the exposure glass cover, or ADF/
ARDF by at least 30 degrees. If you do not, the size of
the original might not be detected correctly.
2. Place the original face down on the exposure glass
so it is aligned with the upper left corner.
3. Lower the exposure glass cover or ADF/ARDF.
Press the
{
Start
}
key.
BDZ016S
1) Limit mark
2) Document guide
BDZ017S
1) Positioning mark
2) Scale
3 Using the Basic Copier and Fax Functions
BDZ010S
BDZ009S