Ricoh Gestetner 5450, Service Manual, Page: 269 / 315

PRINTING SECTION 1 July, 1998
6-78
4. Then, put the pressure cylinder
into the hole where the drum
was using both hands.
5. Install the pressure cylinder,
while positioning the thinnest
part of the shaft of the bearing
[A] with the clamper cam (the
black cam) as shown to the
right. Position the bearing [A]
on the bearing holder.
6. While the round hole [B] is
uppermost, push the pressure
cylinder towards the non-
operation side (to engage the
joint behind the cylinder).
NOTE: 1) If it cannot enter, push
while turning the
pressure cylinder a
little. Check if the joint
is engaged properly by
turning the cylinder
slightly.
2) Set the bearing stopper
[C] as shown.
C229R538.WMF
C229R006.WMF
[C]
[B]
[A]