Ricoh FACSIMILE FAX77, Field Service Manual

Page: 81 / 197

Bit Switch 9
BIT FUNCTION DATA COMMENTS
0 Not used Do not change the factory setting.
1 Black line in the 0: Included If this bit is 1, the black line on the left side of the image (used
image in G2 mode
1: Deleted for synchronization) will be cut out.
(Austria only)
2
Not used Do not change the factory setting.
3 Transmission of 0: Enabled 0: The machine informs the transmitter that it can receive G2
Group Identification 1: Disabled messages.
(Gl) signal in 1: The machine indicates that it cannot receive in G2 mode.
receive mode
Caution: If this bit is 1 and if bit 1 of bit switch A is also 1, the
machine cannot send out any signals.
4 Substitute recep- 0: Enabled In W. Germany, this bit must be 1. This bit is changed by Func-
tion 1: Disabled tion 59 in the FAX80. If this bit is 0, bit 2 of bit switch 8 must
be 1.
5
Not used Do not change the factory setting.
6 Condition for SAF 0: The SAF can receive 0: The SAF can store pages from the other end even if the
memory reception with or without the other end did not send an RTI or CSI. Some users do not
detection of RTI or CSI. bother to program these identifiers, so this bit must be at 0 to
1: The SAF can only receive messages from these users into memory.
receive if CSI or RTI 1: If the machine does not receive an RTI or CSI from the
has been detected. other end, reception into memory is impossible.
7 Not used Do not change the factory setting.
2-50