Ricoh FACSIMILE FAX77, Field Service Manual

Page: 46 / 197

3. Dedicated Transmission Parameters - Function 60
Each fax number programmed as a Quick Dial Key or Speed Dial Code has three tx parameter bytes that can
be programmed. The bytes are explained after the procedure.
Procedure
1.
2.
3.
4.
5.
6.
7.
8.
9.
Enter the service mode. See page 2-13.
Press the Function key, enter 60 at the keypad, then press Yes.
To program for a Quick Dial Key: Press the required Quick Dial Key (press No if you pressed the wrong
key). Then press Yes.
To program for a Speed Dial Code: Press the Speed Dial key, then enter the two-digit code at the keypad
(press No if you make a mistake). Then press Yes.
The display now shows the settings for byte no. 1. The second line shows the current settings of tx
parameter byte number 1. Bit 7 is at the left end of the display, and bit 0 is at the right.
To change the setting of a bit, press the key on the ten key pad that corresponds to that bit. For example,
to change bit 3, press 3.
If the settings of tx parameter byte number 1 are correct, press Yes.
The settings of byte number 2 are now displayed. Repeat steps 4, 5, and 6 for this byte.
The setting of byte number 3 is now displayed. If the setting is correct, go to step 10.
Take the required T1 time, convert it into seconds, and divide it by 2.56. Enter this value at the ten key
pad. You cannot enter 0 or a number higher than 255.
2-15