Remarks
68
5
• The outer portion of the image might not be printed under low temperature.
In this case, either select the slower printing speed, or increase the room tem-
perature.
• The paper exit pawl might come in contact with the printing paper and cause
black lines on the prints. In this case, increase the printing speed or make a
new master with a lighter image density.
• If you cannot pull out the drum, close the front cover again to rotate the drum.
Pull out the drum after it stopped at the position.
• The leading edge of the prints might become stained if the edge touches the
image of prints on the paper delivery tray.
• The ink of the print on the paper delivery tray might stick to the back side of
the next print.
• When the machine is on and the power source is less than 90% of the specified
amount, printing quality will decrease. Therefore, make sure the supply from
your electrical outlet is at least 90% of the required amount.
• As various kinds and qualities of paper exist, some paper might be wrapped
around the drum or cause misfeeds.
• If your hands are stained with ink:
• Avoid prolonged or repeated contact with skin.
• Cleanse skin thoroughly after contact, before breaks and meals, and at the
end of the work period.
• Ink is readily removed from skin with waterless hand cleaners followed by
washing with soap and water.
• Also, be careful not to get any ink on your clothing while emptying the master
eject box or while loading a new ink cartridge.
• The image density varies according to the printing speed and the room tem-
perature. To achieve the desired image density, adjust the printing speed or
increase the room temperature.
• When you make a lot of prints from a small image, ink might ooze out from
the edges of the master, especially under high temperature and when print-
ing in two or more colors. In this case, make a new master.
• Use ink made within one year. Ink stored for a long period of time tends to
dry up gradually and result in lower image density.
• While making a master, do not leave the document feeder cover open.
• When you use originals with light lettering, edges of the letters might be
printed clearly and the inside of the letters might be light. In this case, in-
crease the image density.
• When marks on the printing paper occur, clean the paper feed roller. See p.72
“Paper Feed Roller (paper feed tray)”.
• If you make a print before the ink on the first print dries, the ink may adhere
to the paper feed roller and soil the print. Before printing on the reverse side
of a printed sheet or overprinting on a printed sheet, be sure that the ink on
the first print is adequately dry. See p.72 “Paper Feed Roller (paper feed
tray)”.
C2748608_Titanium3-EN.book Page 68 Wednesday, November 19, 2008 10:25 AM
