Ricoh Aficio 240W, Operating Instructions Manual, Page: 61 / 92

Loading Paper
49
4
Loading Cut Paper
Note
❒
When you change the paper size, make Tray Paper Size setting under System
Settings, see p.35 “Tray Paper Size”.
1. Pull out the cut paper tray while lifting up-
ward and out.
Note
❒
Be sure to load paper after all the paper in
the tray run out.
2. Hold both sides and lift the front of the tray,
and then remove it from of the machine.
3. While pressing the release lever, open the
side fence (
A
).
Note
❒
When changing the paper size, adjust the
end fence to the paper size while pressing
the release lever (
B
).
4. Load paper print face down.
Note
❒
Load paper below the limit mark on the pa-
per guide.
5. While pressing the release lever, adjust the
side fence to the paper size.
6. Insert the cut paper tray into the machine,
push slowly until it stops.
Note
❒
If you push the cut paper tray forcefully,
the tray's paper guide may become out of
position.
NeptuneC1_GBzen_F_FM_pre.book Page 49 Tuesday, December 16, 2003 5:03 PM