GTR061 Installation Manual:
Rev 3
9
For Installing Your Gate Motor, You Will Need:
• Power drill
• Tape measure
• Level
• 12mm Masonry Drill Bit (for the 4 motor masonry anchor bolts)
• Socket and Spanner Set
• Phillips Head Screwdriver
Example Sliding Gate Setup:
If you require any gate hardware, contact Richmond Wheel & Castor Co or an authorised reseller.
Gate Track and
Track Wheels
Gate Guide
Rollers
Gate End
Catch
Gate
Stopper
It is recommended that you allow a
minimum 500mm bottom rail extension
from your inside gate post opening. This will
enable you to have enough room to secure
your gear rack and placement for the motor.
