GTR061 Installation Manual:
Rev 3
12
Step 4 - Drilling Holes for Anchor Bolts:
• Mark the (4) positions for your anchor bolts ready for drilling (refer to Fig 7).
• Remove Mounting plate.
•
Using a M12 masonry drill bit, drill holes to a minimum depth of 120mm (Fig 8).
Fig 7
Fig 9
Fig 11
Fig 8
Fig 10
Fig 12
Fig 13
Fig 14
Step 5 - Fitting Mounting Plate & Motor:
•
Fit motor mounting plate back into place and fi t and tighten anchor bolts (as per fi gures 9 and 10).
• Fit motor back on mounting plate, ensuring the power cord is positioned into the end slot of the mounting
plate in the direction of the power point, making sure there are no pinch points (as per fi g 11).
•
Slide rubber grommet along the power lead and into the end slot of the mounting plate (as per fi gures 12 & 13).
•
Bolt motor to the mounting plate using the M10 x 50mm bolts with spring and fl at washers provided and
tighten as required (as per fi gure 14).
208mm
135mm
Tighten bolts using
spanner or socket set
Insert the M10 x 50mm bolts
(Part 6d), spring washers,
and fl at washers provided
through motor housing and
screw into welded nut on the
baseplate.
Hand-tighten set screws
before fi nal adjustment of motor.
Once the gate has been placed onto the gate motor the gate must move back and
forth freely at all times when in manual release mode
