GTR061 Installation Manual:
Rev 3
15
Step 7 - Limit Travel Stops:
Included in your gate motor kit are two limit travel
stops (Part 7a) which must be fitted to the gear
racks on your gate to ensure safe operation.
The limit travel stops are designed to set the
desired opening and closing position of your
gate. These limit travel stops are designed to
come into contact with the spring limit switch.
Please note: gates can open and close in
different positions due to different weights of
gates, terrains, slopes (uphill or downhill). The
distance the gate will travel after contacting the
spring limit switch may vary.
Instructions on setting the limit travel
stops can be found on the next page
The installation of spring limit switch block is shown in Figure 20
Fig 19
Fig 20
M6 x
10mm
M6 x
10mm
GTR061
Motor
Gear
Rack
Limit
Travel
Stop
Motor
Gear
Cog
Spring
Limit
Switch
Mounting
Plate
This diagram
shows the gate
in the open
position
Fig 21
