GTR061 Installation Manual:
Rev 3
16
Test the spring limit travel stops by moving the gate manually until you hear a click, making sure contact is
made with the spring limit switch on the motor.
To Reset:
When setting new limit travel stop positions please ensure that you turn the power off and then on
again. Turning the power off will reset the limit travel stop memory, allowing for new limit travel stop positions to
be recognised by the motor.
Once satisfi ed the gate is opening and closing to the test limit switch position. Set the limit travel stop positions
in place (see Step 8 and Step 9 for instructions on powering the motor and testing the limit switch positions).
Open Position:
• Position gate 150-200mm back from
the gate stopper open position. This
will help in making sure you do not
slam the gate into the end stop/catch
when setting the open position under
power.
• Fit limit travel stop onto the top of
gear rack at the point where it meets
the spring limit switch on the motor.
• Tighten locking screws.
Setting the Limit Travel Stops:
Fig 23
Fig 22
Closed Position:
• Position gate 150-200mm back from
the gate end catch closed position.
This will help in making sure you do
not slam the gate into the end stop/
catch when setting the closed position
under power.
• Fit limit travel stop onto the top of
gear rack at the point where it meets
the spring limit switch on the motor.
• Tighten locking screws.
