Richiger EA 910, Operator'S Manual

Page: 27 / 76

11
Back to transport mode
Reverse the order of previous steps to set up the machine for transport:
a) Raise hydraulic cylinder to its maximum height, clamp all the stops on the
cylinder rod and lower again to rest machine on stops. It is important to set
highest clearance for the road.
b) Fold the discharge auger.
c) Disconnect hydraulic hoses and remove PTO drive shaft.
d) After lifting up the pivoting support stand, swivel roller cross beam ¼ of a
circle into its transport position. Then remember to secure support stand to
its base once again.
e) Turn cutter blade round so cutting edge faces inward.
f) Remove outer sweeper screws and grids so machine does not exceed road
transport width allowance.
g) Hitch unloader to towing vehicle.
Fig.37 Fig.36
c) Go forward with tractor and
unloader until all of the used
plastic is released from the
roller and lies on the ground
(Figs. 36 & 37).
20