Beijing RichAuto S&T Co., Ltd.
Forging ahead and determined to win 78
5.
Repeating the same processing file after backing to the machine origin,Z axis depth is not
the same
1)
Machining countertop is uneven or processing object not firmly fixed, re-milling countertop
adjust the flatness.
2)
Z-axis origin detection switch repeat positioning accuracy error, causing each Z axis homing
error. Replace a high-quality detection switch.
3)
Too much interference in the Z-axis homing process to form a false origin. Re-adjust the
cable.
6.
The machine can not stop after backing to the machine origin
Double press
“
”
to check input signal.
1)
The origin detection switch is broken. Replace a new one.
2)
The distance of the origin detection switch detection sheet beyond the detection range of the
switch, adjust the position of the test piece.
3)
The origin detection switch to the interface board wiring aging or loosening. Check the
connections again.
4)
The interface board is broken. Depot Repair.
5)
50-pin data cable is broken. Replace it with a new data cable.
7.
The machine moves to the reverse direction when backing to the machine origin
1)
The origin detection switch types do not match with the definition of the corresponding
level. Modify the level. (Normally open type corresponds to a level defined the direction of
the arrow down, normally closed type corresponds to the level defined arrow up).
2)
The origin detection switch is broken. Replace a new one.
3)
The origin detection switch connects interface board not well. Refresh the cable to confirm
the wiring is correct.
4)
Too much interference, resulting in the illusion of the detection switch has been
triggered. Recalibrated the whole circuit.
5)
The interface board is broken. Depot Repair.
6)
50-pin data cable is broken. Replace the data cable.
