8. Starting a warm engine:
If fuel tank was not run dry, pull recoil starter handle one to three times and it should start.
If fuel tank was run dry, after refueling repeat above steps 3 through 7 WITHOUT using the choke.
Note: Always allow engine to warm up before use by pressing lightly on throttle lever.
Fig.7
Fig.8
(a) Interrupteur
marche/arrêt; (b) Bouton de
verrouillage;
(c) Gâchette accélérateur
Fig.9
(1) Starter;
(2) Fermé;
(3) Ouvert
Fig.10
4.5.2- Stopping the engine
1. Release the throttle lever to allow the engine to idle for a few minutes.
2. Set the switch to the “STOP” (0) position. (see Fig.8)
WARNING!
- Make sure to perform warm up with the cutting element attached.
- Keep away from cutting element as it starts to rotate when engine starts.
- Before starting engine, ensure cutting element is clear of surrounding objects.
Note:
When restarting the engine immediately after stopping it, put choke lever in open position.
4.5.3- Adjusting the carburettor
The carburetor is adjusted in factory before shipment.
Do not adjust carburetor unless necessary.
If you have trouble with the carburetor, contact an authorized service center.
Note: Improper adjustment may cause engine damage.
V. OPERATION
5.1- Intended use
The product is intended for trimming, edging… grass, weeds and small bushes
5.2- Operation
Check points before operation
1. Check for loose bolts. Nuts and fittings.
2. Check the air cleaner for dirt. Clean the air filter of all dirt. Etc. before operation.
3. Check to be sure that protector is securely in place.
4. Check to be sure that is not leak.
5. Check to be sure the blade is not running in idling speed.
WARNING!
Do not allow anyone to enter the
operating DANGER ZONE with you.
The danger zone is an area 15 meters in radius
(about 16 paces) or 50 feet (Fig.11).
Fig. 11
Page
44
/
49
