
OPERATION
SE8A 01/11
Operation Section 4-4
© 2011 Alamo Group Inc.
OPERA
T
ION
2. TRACTOR REQUIREMENTS
The tractor used to operate the mower must have the power capacity to lift, pull, and operate the Power Take
Off (PTO) at the mower’s rated speed while traveling at a ground speed between 2 and 5 MPH. Operating the
mower with a tractor that does not meet the following requirements may cause tractor or mower damage and
be a potential danger to the operator and passersby.
Tractor Requirements and Capabilities
•
ASABE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.
•
Tractor Safety Devices ..................................... Slow Moving Vehicle (SMV) emblem, lighting, PTO master
shield
•
Tractor Horsepower:
-Minimum .................................. Lift - 45 HP, Pull - 30 HP
-Maximum .................................. 90 HP
•
Drawbar Vertical Load Minimum Capacity ....... 600 lbs.
•
Hitch -Lift Type Mower:
- Lifting Capacity ........................ 1300 lbs.
- 3-Point Hitch............................ CAT II Standard. Cat I Optional
-Semi-Mount:
-3 Point Hitch ............................. Cat II Standard. Cat I Optional
-Hydraulics................................. Optional
-Pull Type Mower:
-Drawbar .................................... Positioned 14” from PTO stub end to hitch hole
-Hydraulics................................. Optional
•
Front End Weight ............................................. As needed to maintain 20% weight on front axle
•
Power Take Off................................................. 540 RPM 6-spline, 1-3/8” diameter output shaft
2.1 ROPS and Seat Belt
The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat
belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be
crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened.
Tractor models not equipped with a ROPS and seat belt should have these life saving features installed by an
authorized dealer.
OPS-U- 0003
Operate this Equipment only with a Tractor equipped with an approved roll-
over-protective system (ROPS). Always wear seat belts. Serious injury or
even death could result from falling off the tractor--particularly during a turnover
when the operator could be pinned under the ROPS.
(SG-7)
Summary of Contents for SE8A
