RHINO RC 115, Operator'S Manual

Page: 94 / 128

MAINTENANCE
RC115/118/120/125 02/12 Maintenance Section 5-6
© 2012 Alamo Group Inc.
MAINTENANCE
ROUTINE MAINTENANCE:
1. Inspect belt drive for correct tension and remove
any debris from inside belt shields. Incorrect
tension will result in premature belt failure. Check
belt tension after first hour of operation.
Mnt-FL-
0029_A.
2. Inspect for and tighten any loose fasteners.
3. Routinely inspect cutter shaft for missing or worn
knives. Replace knives as outlined in Blade
Replacement Procedure.
Mnt-FL-0037.
4. Clear any debris from gear box area, to prevent
overheating. Clean area around breather plug
regularly.
5. Always ensure all hitch pins and clips are locked in
place before operation.
6. Inspect bearing assemblies to ensure locking
collars are locked in place.
7. All shielding must be in place before operating
shredder. Inspect front rubber shield for wear and
replace if necessary.
CUTTER SHAFT
Routinely inspect cutter shaft for and replace any worn or damaged blades. When replacing worn blades
always replace blade set directly opposite, (180 degrees) otherwise cutter shaft will be out of balance. Inspect
bushing and bolt for wear and replace if necessary. Remove any debris which may become entangled around
cutter shaft or bearings. Stop machine at first sign of excessive vibration and inspect cutter shaft and bearings.
BLADE REPLACEMENT
1. Remove locknut (item 1), bolt (item 2), and
inspect bushing (item 3) and bolt for wear.
Replace if worn.
2. Place new knives on bushing and insert between
reel clip. Tighten to 60 ft. lbs.