RHINO RC 115, Operator'S Manual

Page: 107 / 128

MAINTENANCE
RC115/118/120/125 02/12 Maintenance Section 5-19
© 2012 Alamo Group Inc.
MAINTENANCE
STORING THE RC115/118/120/125
When storing the unit for an extended period of time, or at the end of a season, lubricate all bearings with
enough grease to eliminate any cavities where water condensation may occur and cause damage. Refer to
“Lubrication” for location of all grease fitting. Be sure the vent on top of the Gearbox is open.
NOTE: IMPORTANT - Use a hand grease gun. Do not over-lubricate. Too much grease may damage the
bearing seals.
Relieve drive belt tension. See “Belt Adjustment”.
NOTE: Before next season's use be sure to adjust the drive belt tension.
Coat all exposed surfaces inside the shredder with oil or grease to prevent rusting and pitting during
storage.
Pre-season Check
1. Check the oil level in the Gearbox and lubricate all bearings. See "Lubrication".
2. Adjust drive belt tension. See “Belt Adjustment”.
3. Inspect for missing and / or broken Blades / Knives. Replace as necessary. See "Knife Replacement".
4. Be sure that the Safety Guard is in place and secure.
5. Run the Shredder at a low RPM checking to make sure that all driveline parts are moving freely.
PROPER TORQUE FOR FASTENERS
The chart lists the correct tightening torque for fasteners. When bolts are to be tightened or replaced, refer to
this chart to determine the grade of bolts and the proper torque except when specific torque values are
assigned in manual text.
RECOMMENDED TORQUE IN FOOT POUNDS UNLESS OTHERWISE STATED IN THE MANUAL*
NOTE: These values apply to fasteners as received from supplier, dry or when lubricated with normal engine
oil. They do not apply if special graphited or molydisulphide greases or other extreme pressure lubricants are
used. This applies to both UNF fine and UNC coarse threads.