INSTALLATION INSTRUCTIONS
MOUNTING
1. Mount the alarm in the engine compartment. Be careful not to mount it near hot exhaust
manifolds or areas that are subject to moisture. A position on the firewall is preferable. The siren
should face forwards.
2. Mark & drill two 3/16” holes to fix the mounting bracket. Screw bracket tightly to vehicle.
3. Mount the alarm to the bracket with the nuts, bolts and lock washers supplied. Ensure that the
only thing that will transmit vibrations to the alarm is through the mounting bracket. If hoses etc.
rest on the unit shock sensitivity will be increased.
4. The LED status indicator should be mounted in a highly visible area. Once a suitable location is
chosen, drill a 5/16” hole. Run the LED wires through the hole then press the LED housing into
place. Route the LED wires to the control module.
5. After finishing the installation ,wiring
and
programming, remove the two screws that hold the
upper case on top of the siren. Insert a 9V Alkaline battery into the compartment and attach the
battery clip. Connect the other end to the adjacent 2 pin connector. Replace the cover.
I M P O R T A N T N O T E F O R I N S T A L L E R S
:
V e h i c l e s f i t t e d w i t h n e g a t i v e
o r p o s i t i v e s w i t c h i n g d o o r s .
I n o r d e r f o r t h e a l a r m s y s t e m t o f u n c t i o n c o r r e c t l y , i t i s n e c e s s a r y f o r t h e d o o r s t o b e
h a r d w i r e d t o t h e s y s t e m . P l e a s e f o l l o w t h e w i r i n g d i a g r a m s b e l o w
:
N E G A T I V E S W I T C H I N G D O O R S : P O S I T I V E S W I T C H I N G D O O R S :
U s e r e l a y .
+ 1 2 V
I n t e r i o r l i g h t
B L U E w i r e
A L A R M 8 6
3 0 8 7 a 8 7 B L U E w i r e A L A R M
D o o r S w i t c h
8 5
D o o r S w i t c h
+ 1 2 V
IMPORTANT NOTE:Vehicles fitted with an interior light delay.
Some vehicles fitted with an interior light delay require a diode to be added
to prevent the system triggering due to voltage drop (current sensing).
Please follow the wiring diagram below
:
Interior light
DOOR DELAY
CIRCUIT
l
l
l
l
l
l
l
l
+12V
Blue wire
Place a diode here
RHINO
Door Switches
OPTIONAL 30/40AMP IMMOBILISATION CIRCUIT
Install 30/40amp changeover relay as shown below:
To orange wire from alarm (negative on arm -500mA)
87
IGN
86
87a 85
30
"
CUT
Original wire to fuel pump/starter motor/ ign. coil