AUTOMATIC REARM
This alarm is equipped with
automatic rearming.
If a door is not opened within 30 seconds of disarming, the system
will automatically re-arm itself. A confirmation beep will be heard to indicate that the system has rearmed itself.
If the
alarm is triggered
, pressing remote
Button 1
once will cancel the siren and rearm the system. The siren will beep
once. Press remote
Button 1
again to deactivate the system. The siren will beep four times and the indicators will flash
three times.
ALARM MEMORY
If the alarm has been triggered in your absence, the siren will beep four times on disarm & the indicators will flash three
times . The LED will then indicate what has triggered the system:
1 Flash...pause...1 Flash....
Trigger on current sensing.
2 Flashes...pause...2 Flashes...
Trigger from pinswitch or neg. trigger connected to blue wire.
3 Flashes...pause...3 Flashes...
Trigger from shock sensor.
The memory readout is given for 30 seconds after disarming, or until the ignition is turned to on.
EMERGENCY PANIC BUTTON OPERATED VIA REMOTE
The panic feature is activated by pressing
Button 1
on the remote control transmitter for
3
seconds. This sets off the
siren. To cancel “panic”, press
Button 1
on the transmitter for
1
second.
REMOTE CONTROL CAR LOCATOR
This feature is activated by pressing
Button 2
on the remote control transmitter for
2
seconds. The siren will beep once
and the indicators will flash 12 times to help you locate your vehicle.
DELETE SHOCK SENSOR
This feature enables the alarm system to be armed without the shock sensor being activated. Simply press
Button 1
twice
within
3
seconds when arming. A confirmation chirp is heard for each press.
TRIGGERING
The siren sounds for 30 seconds then it will reset and rearm itself automatically.
Your Rhino Accel+ Alarm can be triggered by the following three methods:
1.
TWO STAGE SHOCK SENSOR (PRE-WARNING SYSTEM)
This special feature provides a two stage impact sensing system. It gives the security conscious owner a sensitive
impact sensor that will give a potential thief prior warning that the vehicle is protected by this alarm system. When the
vehicle is “hit” lightly the siren will simply chirp to warn away the thief. If the vehicle is attacked with a higher level of
impact (i.e. break glass), the system will move into full siren mode.
2.
CURRENT SENSING
This feature allows the alarm to be triggered by sensing a drop in voltage through the vehicles electrical system. Where a
door or boot/bonnet switch are wired to the interior light circuit, the alarm will sense the light coming on through the
drop in voltage and trigger the system. The interior light/s must be set to turn on when the doors are opened. The alarm
must be wired to the vehicles interior light circuit exactly as described in the proceeding wiring instructions for this
system to function correctly. If there are accessories in the vehicle that use power after the vehicle is switched off i.e.
car fridges, some mobile phone kits, thermo fans etc. then removal of this feature will be required. See wiring
instructions detailed later.
3.
NEGATIVE TRIGGER INPUT
(Grounded pin switch)
This feature allows the alarm to be triggered by a negative signal from door/boot/bonnet switches or from optional
sensors such as ultrasonic or microwave detectors.
