13
0
Diagram 5e
Only qualified
personal should attempt to work on this equipment.
There is very little that can go wrong with the Coil Inserter Module. Most
of the problems are due to setup error. There is one fuse located at the rear of
the inserter that can be replaced by the customer. Here is a small
troubleshooting guide to help you through some of the problems that may be
encountered.
Troubleshooting
Symptom Possible Cause Action
Drive wheel does not rotate. 1)
Machine is off. (switch is I) Place switch in either
(There is a thermal overload
in center position) Forward or Reverse
built inside of the motor. Wait 2) Machine not plugged in, posibon.
several minutes below
3) Blown Fuse. 2)
checking
the fuse)
Check both ends of power
cord.
3) Check Fuse 1. (5amp)
Coil tightens on the mandrel 1)
Mandrel is too small for
when inserting.
I) Select proper size
coil.
mandrel. (see page 12)
Coil stops before it is
completely through the book.
1)
The holes in the book are I
This is normal. Try moving
misaligned. the book around so the
2)
The coil is beyond drive coil rotates in the holes.
wheel. 2)
Coil length may need to
be longer for that
particular book. Note: On
larger coils, they can wind
themselves open so that
Summary of Contents for OD 3500
