3) Preparing your HD-7700 for the APES-14-77:
¾
Unplug HD-7700 from outlet! DO NOT OPEN COVER!! Hazardous
voltage inside! Crush hazard! Keep hands away from moving parts!
¾
Unplug foot pedal and store (the APES-14-77 has a foot pedal). See Figure
B.
¾
If you have a Palm Switch attached to your HD-7700, unplug, detach and
store.
¾
See Figure B and Un-tighten completely #1-Knob and remove #2-Paper
Pointer Guide from #3-Adjustable Mounting Block. Store these Items.
Fig. B
¾
Your APES-14-77 came with two required Interface Blocks (Figure C page
5) that are 9” long by ¾” Square, and four ¼-20 X 1-1/4” socket head cap
screws, and an Allen wrench for securing the APES-14-77 to the HD-7700.
You will fasten them to the sides of the HD-7700 punch next.
¾
On each side of the HD-7700 locate the top most and two forward most
Allen screws and remove them using the short side of the Allen wrench for
leverage and turning counter clockwise see Figure “C” (page 5) for location.
¾
Orient an Interface Block with the oval hole forward as shown in figure C
(page 5), and round hole to the rear of the HD machine over the two
available holes. Make sure the counter bores in the blocks face outward.
See the counter bore example in Figure D (page 5). Note the nine other
mounting holes will face up and down. Screw in the longer supplied socket
heads just a few turns with your fingers.
Page 4
Issue “A1” 09/03 P/N 900599 www.RHIN-O-TUFF.com
